Support Topics
Mount the Repellers
Depending on your installation and selected hardware, follow the appropriate step below to attach a repeller.
Standard Mount - Decks, Railings and Flat Wood Surface
- Secure the mount directly to the surface using deck screws
- Route cables through the cutout in the mount
- Slide the repeller onto the mount until it clicks into place
Ground Stake - Lawns, Garden Beds and Mulch Areas
- Push stake in by hand until just above ground level (Do not use a hammer or mallet)
- Twist the standard mount onto the stake until finger-tight
- Align push tabs and pass pigtail connectors through cutouts
- Slide the repeller onto the mount until it clicks
Hardscape Base - For Stone, Pavers, Decking, or Other Hard Surfaces Where Drilling is Not Desired
- Twist the standard mount into the threaded center of the base
- Pass pigtail connectors through the bottom of the base
- Slide the repeller onto the mount until it clicks
- Place base on surface, ensuring cables sit in the edge cutout
Side Mount - For Decks and Vertical Hard Services
- Position the side mount and mark hole locations
- Pre-drill two holes and secure side mount with appropriate screws
- Twist the standard mount onto the side mount
- Route cables through cutouts and install the repeller
- Secure cables with a zip tie.
